What causes signal loss in cables?

Signal loss comes from three sources: conductor resistance (converts signal energy to heat), cable capacitance (rolls off high frequencies) and connector losses. Balanced cables (XLR, TRS) reject noise far better than unbalanced (TS) cables over long runs.

How long can I run an XLR cable?

Balanced XLR cables can typically run 100+ metres with negligible loss. The CMRR (Common Mode Rejection Ratio) of balanced connections cancels induced noise. For critical recording, keep runs under 50 m for the lowest noise floor.

Why are instrument cables limited to short runs?

Guitar/bass instrument cables (TS) are unbalanced and have high source impedance from passive pickups (~10kΩ). Combined with cable capacitance, this creates a low-pass filter that dulls the tone. Keep TS cables under 6 m for best tone.

Does cable gauge matter?

For speaker cables, gauge is critical because high current flows through low impedance. Use thicker cable (lower AWG) for longer runs and lower impedance speakers. For mic and line cables, standard 24 AWG is fine for runs under 30 m.

AudioCalcs

Cable Loss Calculator \u2014 Signal Loss Over Cable Runs

Calculate signal loss, noise floor impact and impedance for audio cable runs.

Cable TypeSelect the type to use

Cable Length

Length measurement

Signal LevelEnter the signal level

Cable GaugeEnter the cable gauge

How We Calculate This

Signal loss = resistance loss + capacitance loss + connector loss

Resistance loss (dB) = 20 × log10(1 - R_cable / R_load)

HF -3 dB point = 1 / (2π × R_source × C_total)

Cable capacitance creates a low-pass filter with the source impedance. This effect is most pronounced on unbalanced cables with high-impedance sources (guitar pickups).

Frequently Asked Questions

Related Calculators

Cable Length Calculator

Calculate the maximum cable length before signal degradation for XLR, TRS, TS and other audio cable types. Free online calculator.

Signal Loss Calculator

Calculate audio signal attenuation in dB over a cable run based on cable type, length and frequency. Free online audio calculator.

Cable Impedance Calculator

Calculate the characteristic impedance of audio cables from conductor diameter, spacing and dielectric constant. Free online tool.

Connector Calculator

Reference guide for audio connector pinouts, wiring diagrams and signal levels covering XLR, TRS, TS, RCA and more. Free online tool.

Balanced vs Unbalanced Calculator

Compare noise rejection and maximum cable run lengths for balanced versus unbalanced audio connections. Free online comparison tool.

Last updated: March 2026

All calculations are estimates based on standard formulas. Always verify results for critical applications.